Chrome Letters Installation

DashKitMall.com - Chrome Letters Installation Instruction

READ THIS GUIDE BEFORE INSTALLATION

If you have any questions about your Dash Trim Kit or the installation process please contact us BEFORE starting your installation. Installation will take 10 - 20 minutes depending on set size.


Download Installation Instruction

| INSTALLATION

Letter Set Package includes:

1 Chrome Letters Set
1 Printed Installation Sheet
1 Isopropyl Alcohol Wipe
1 3M Adhesive Stick / Sachet


What you will need for your Letter Set installation:

Hair Dryer or Heating Gun,
Clean, Lint Free, Soft Cloth
10-20 minutes of time depending on your set size

| Step 1

Thoroughly clean the area where the pieces are to be applied with a clean, lint-free cloth and the alcohol swabs provided or with 3M Solvent 70*, to remove ALL residue and dirt.

A test can be performed for cleanliness with ordinary masking tape, if the tape sticks easily to the surface, if not repeat the cleaning process.

| Step 2

Without removing the red backing tape, 'dry-fit' ALL pieces, noting correct placement, joins and angles.

Very Important Note:  ALL pieces should be checked "dry-fit" before proceeding to Step 3. Immediately stop installation procedure and contact us even if one piece doesn't fit.

Any money back or refund requests based on fitting issues will be declined once the kit or partial pieces are installed. Only replacement and correction requests will be reviewed and accepted.

| Step 3

Apply the 3M Adhesive Promoter provided with our set to the installation area, ONLY TO SURFACES THAT WILL BE COVERED by letters, pay special attention to the edges of all pieces to prevent lifting.

The 3M Adhesive Promoter Stick/Sachet will dry out in approximately 10 min, please make sure you apply it to all required surfaces BEFORE proceeding to Step 4.>

| Step 4

Gently heat the parts with a hairdryer or heat gun set to low. Keep the heat source at least 5" away from the piece. Pieces will become flexible with application of heat.

Placing the pieces (backing tape side down) on the top of the dash with the front window defrost set to medium for 15 minutes, warms & keeps all pieces ready for installation.

Alternately, on sunny days, laying the kit in the sun for 10-15mins will have the same effect.

| Step 5

Hold the pieces by the edges to avoid touching the adhesive surface. Peel Red Protective tape out, place piece in position, align correctly and thoroughly press down on the entire surface of each piece to ensure a complete 'wet-out' of adhesion to the surface.

Repeat this step for all pieces you have.

When red backing tape removed  DO NOT TOUCH  3M adhesive surface!

| Step 6

Remove front side clear or white protective tape from all pieces.

| Step 7

Enjoy our product.

Please do not hesitate to contact us at service@dashkitmall.com with any questions or concerns regarding this particular set or your future purchase. Our Customer Support representatives are always happy to help you.